Hunter L111 DSP250 Sensors Windows Alignment Software

This project convert old DSP 250 Wheel Alingment sensors to use modern Windows based software. Software is Vibe coded using Opus 5.5 and available to download further down on this webpage. Old main frame is not needed after conversation.

Sensors are connected to each other using module cable. Each sensor has own ID. Communication format is RS422. Here is pinout for cable side plug

1: Data from host Hi
2: Data from host Lo
3: Data from sensors Hi
4: Data from sensors Lo
5: GND
6: +12 VDC
7: +16.5VDC
9: -16.5VDC
10: +12 VDC

Main frame internal connector cable


Power supply outputs

Main PCB Power and sensor connections

It is also possible to add adapter cable between PCB and wiring harness that routes power pins from pcb to sensors and sensors RS422 pins outside of box. This way other side two connectors can be used with Windows PC and other side two connectors normally with original system.

RS422 lines can be connected using two MAX485 boards to FT232 USB to serial adapter

Software

https://kivijakola.fi/share/HunterAlign-Setup-1.0.0.exe.zip

Caster measurement with SW

All wheel alingment limit values are editable.